Brick® 600 Heat Transfer Vinyl Brick is CPSIA Certified so it’s perfect for decorating children’s clothing and accessories. | |
Specifications: PU Composition • Pressure sensitive backing • Matte finish • 600 Microns/23.6 Mils • 45°/60° blade |
CUTTER SETTINGS | |||
Cricut: Blade: Standard Cardstock Light+ | Silhouette Cameo: Blade: Standard, 10 Material: Heat Transfer, Flocked Speed: 4 Force: 33 | Scan N Cut: Blade: Standard, 10 Cut Speed: 1 Cut Pressure: 2 | |
Roland GS/GX-24: Blade: 60° * Gram Force: 150-190 Offset: .250 Speed: 30 cm/s | Graphtec: Blade: 60° * Gram Force: 11-12 Tool: CB09U+0 Speed: 25 cm/s | MH, SC2. LP3, & Titan 1: Blade: 45°/60° Gram Force: 120-130 Speed: 300mm/s *Blade Advancing Varies | Titan Series Blade: 45°/60° Gram Force: 100-110 Speed: 300mm/s *Blade Advancing Varies |
Settings may vary based on blade condition and age of machine. Always perform a test cut prior to cutting designs.* For Roland & Graphtec cutters, due to the material thickness, extend the blade out so that a significant amount of blade is exposed. |
APPLICATION INSTRUCTIONS | |
Application Instructions (home iron) • Set iron dial between Cotton and Linen • Cover design with Kraft paper or non-stick cover sheet • Place on flat, hard surface (ironing board not recommended) • Press iron with medium/firm pressure (do not slide iron) • Press each section of design for 10-15 seconds • If areas of design lift after application, replace cover sheet and re-press for 10 seconds • Peel carrier cold | Application Instructions (heat press) • Cut in Reverse • Weed excess material • Preheat garment for 2-3 seconds • Apply design at 311°F/155°C • Use medium/firm pressure for 20 seconds • Peel carrier cold |
RECOMMENDED ACCESSORIES & CARE | |||
Brick 600 Applies to: 100% cotton Poly/cotton blends 100% polyester | Recommended Accessories: Siser Weeder | Laundering: Wait 24 hours before 1st wash Machine wash cold / mild detergent Dry on low dryer setting Do not dry clean |